On eBay Now...

Dead Water Finisher (Frequency Controlled Vibration Gold Cons Finisher) For Sale

Dead Water Finisher (Frequency Controlled Vibration Gold Cons Finisher)
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Buy Now

Dead Water Finisher (Frequency Controlled Vibration Gold Cons Finisher) :
$85.00

The Dead Water Finisher is a gold concentrate vibration finisher designed in the United States by Prospector Tripp. This innovative product is used for cleaning up gold concentrates. This is a terrific interactive hobby mining tool that is loads of fun to operate while cleaning your gold concentrates. With its frequency-controlled vibration technology, the Dead Water Finisher ensures precise frequency controlled \"gold walking\" out of your cons, making it a super fun, enjoyable interactive finishing tool.

Built with quality and precision in mind, this product is a valuable tool for those in our crazy fun hobby mining industry looking to improve their overall fun and enjoyment while finishing your gold concentrates.


Comes complete, ready to run out of the box with batteries included and installed. 

I personally build and test every single unit to ensure that they function properly.


You will need.. regular ac household power,  a suitably sized wash tub (14x12x4 inches is large enough) set on a flat surface, like a kitchen table or work bench. Add about 1 3/4\" of water and a shot of Jet Dry.

Plug it in (you may have to prime the 160gph fountain pump) also the pump intake faces downward to prevent it from sucking air. After the water is pumping, place a small amount of your gold concentrates in the MIDDLE.. (not at the top or at the bottom, but in the CENTER OR MIDDLE of the wash plate). Switch on the vibration power in the back. Then, adjust the speed controller until the gold begins to move upward. I have found that  about at setting #2 is enough to get things moving. Please experiment with the vibration speed to find your best vibration frequency for your gold cons. Snuffer up the clean gold as it climbs out of your cons. Adjust the frequency as necessary as well as brush your cons back to the CENTER the wash plate.  Keep snuffering up the clean gold until complete. As you get most of the gold removed, you may want to lift the backside of the Dead Water Finisher a few milliliters and wash off some of the dirt and magnetite to free up the possible fine gold remaining. 


Please experiment and have fun learning this terrific tool. I have really enjoyed using this finisher.

You will likely enjoy it, too!

It is a blast! 100%


Lastly.. this unit is a 3d printed and is sensitive to extreme heat.. please use indoors or in the shade outside. Direct sunlight can warp 3d printed products. The Dead Water Finisher also has an electric speed controller that can not be doused in water. Please be careful not to get it wet or submerge it, or it will likely fail.


Stay Golden ⚡️

Peace Prospector Tripp

Buy Now

Popular

Recent Posts