This item has been shown 21 times.
The Hioki 3282 digital clamp-meter is a true RMS sensing, auto-ranging multimeter for measuring current, voltage, frequency, and resistance in electrical testing applications. It has a clamp that measures AC (alternating current) to 1,000A (amperes). The clamp has two jaws that can close around an electrical conductor up to 46mm (1.81 inches) in diameter to measure current without touching or interrupting the circuit. A set of test leads is included for measuring AC voltage to 600V, frequency to 1,000Hz (hertz), and resistance to 10kΩ (kilohms). The meter has a rotary switch to select the property to measure, and a 3,000-count LCD that shows the reading numerically and in a 35-segment bar graph. The crest factor function uses a 1.00 to 5.00 scale to measure the quality of an AC signal and its ability to generate a particular voltage or current. The record function displays the maximum, minimum, and average readings for a property after the function is engaged. To aid documentation of readings and capture readings in tight spaces, the data hold function keeps the most recent reading on the display after disconnecting from the circuit. A continuity buzzer confirms that the circuit conducts electricity. The unit operates on a single 9V 6F22 battery, and turns off automatically after 10 minutes of non-use to conserve battery life. It has a low-battery indicator that signals when the battery needs to be replaced.This true RMS (root mean square) sensing meter provides accurate readings when measuring linear or non-linear loads, regardless of the waveform. It is auto- ranging, so it automatically selects the appropriate operating range for the property being measured. Accuracy and resolution specifications vary according to the range being measured. The meter meets EN (European Standard) safety standard 61010, and is rated for CAT (category) IV installations up to 600V, which covers equipment at the origin of the installation, such as electricity meters and primary over-current protection equipment. It has CE (European Conformity) marking. The unit comes with a carrying case.SpecificationsMaximum AC (alternating current) input1,000AMaximum AC voltage input600VMaximum frequency detected1,000HzMaximum resistance detected10kΩInstallation ratingCAT IV, 600VStandards metEN safety standard 61010; CE markingPower supply 9V 6F22 batteryWeight400g/14.1oz.Dimensions (H x W x D)230 x 62 x 39mm/9.06 x 2.44 x 1.54 inchesH is height, the vertical distance from lowest to highest point; W is width, the horizontal distance from left to right; D is depth, the horizontal distance from front to back.Clamp-meters, also called clamp-on meters, have two jaws that fit around a conductor to measure electrical current without cutting through wires, or touching or interrupting the electrical circuit. Available in handheld or benchtop models, clamp-meters diagnose problems in electrical equipment, wiring, and power supplies. All clamp-meters test for current. Some come with test leads and inputs for measuring voltage, capacitance, and resistance. They display information either in analog or digital form. Factors that influence meter choice include the electrical properties to be measured, the anticipated range of results, and the desired level of protection against transient voltage. Safety ratings are based on International Electrotechnical Commission (IEC) standards for low-voltage test equipment. IEC 61010 delineates four overvoltage installation categories. In general, a meter with a category IV rating will provide more protection against transient voltages than a meter with a lower category rating. Hioki manufactures memory recorders, automatic test equipment, and electronic testing and measurement instruments. The company, founded in 1935, is headquartered in Japan and has a U.S. office in Cranbury, NJ.What's in the Box?Hioki 3282 digital clamp-meterTest lead set9V 6F22 batteryHand strapCarrying caseInstructionsFeatures
Most orders are shipped within one business day with standard shipping and tracking number. Tracking information will be automatically uploaded as soon as the item has been shipped.
Please make sure to provide the correct shipping address during checkout as the address cannot be changed after checkout. We are not responsible for any incorrect or undeliverable addresses.
We do not ship to AK, HI, PO boxes, or APO addresses.Return Policy All returns accepted within 14 days after receiving the item, refund given as money back (no exchanges permitted), return shipping to be paid by buyer. 15% restock fee will be charged for all returns. Buyer is responsible for return shipping on any item that is not damaged.